2
MENU AND SETUP FUNCTIONS
The menu switch, which is located above the character display, is used to configure the Show Designer 2
for your particular lighting setup. The left and right cursor switches, the + and - switches, and the data
input wheels allow you to select settings for the various menus that appear on the display. Pressing the
menu switch displays the message “Select a menu item then press enter” on the top line of the display. You
will be given a choice of menu items on the bottom line of the display. You can cycle through the choices
using the + and - switches or the #1 data wheel. Press “enter” to select the desired menu item. After
selecting from the menu, the cursor switches will allow you to select a field on the display to edit and the +
and - switches will allow you to change the value in that field. An underline cursor shows the selected field.
You can also use one of the four data wheels under any field that you want to change. (The wheels don’t
require you to select a field using the cursor switches). The “enter” switch must always be pressed
following any change made to a menu item to make it permanent. This allows you to look at all of the
possible choices first.
Several of the menu choices are hidden to prevent unauthorized or accidental changes to the memory. The
“memory lock/unlock” function is hidden as well as the “erase all memory” function. These choices can
only be selected by pressing and holding down the “add” switch while selecting these last items from the
menu list. This is a safety feature for the benefit of installers who wish to protect the memory from
unauthorized tampering.
The various menu items are explained in the following paragraphs.
CHOOSE FIXTURES
This allows you to select from a list of lighting fixtures in the fixture library. First use the + or - switch or
the #1 data wheel to select the fixture number (from 1 to 48), then select the type of fixture with the #2
data wheel or move the cursor to the fixture type and use the + or - switch. You must press “enter” to
record the choice. You can also press “erase” to select “No Fixture”. If auto patch is enabled, a warning
will appear telling you that some DMX start addresses may be changed. Press “yes” to confirm or “no” to
exit. After pressing “yes” the message “DONE” will appear for 1 second. If auto patch is enabled, the start
addresses of any fixtures above the selected fixture will be adjusted to accommodate the new fixture.
The Show Designer 2 has a built in list of fixtures to choose from. You can also load in “fixture profiles”
that contain more detailed information about a particular lighting fixture than what is offered by the built
in list. Fixture profiles are small files that can be downloaded from elationlighting.com. They can then be
loaded into the Show Designer 2 using the disk drive or through the RS-232 port if you don’t have the disk
drive option installed. Read the section on loading fixture profiles for more information.
When selecting fixtures from the “Choose Fixtures” menu, any profiles will be followed by “(profile)” in
the display.
PATCH FIXTURES
This allows you to turn auto patch on and off or allows you to change the output port and set the DMX
starting address for each fixture manually. Auto patch must be turned off to change the start address or
port of any of the fixtures. To turn auto patch on or off, place the cursor under the words “ON” or “OFF”
below “AUTO PATCH”, then use the + or - switch to select on or off or use data wheel #4. You must
(60 Seiten)
(16 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern