15
To save the preset, select the page and number where you want to store it. If you select a number that is
already lit, a message will appear asking if you want to write over the existing preset. Press “yes” or “no”.
You can use the page switches to select from pages 1 to 24 which will allow you to store up to 1152
presets. You cannot record over or edit the factory presets on pages F1 through F4.
Note: It can take up to 30 seconds to overwrite or erase a preset depending on how much of the memory
is currently filled.
After saving a preset, record mode stays on allowing you to continue to record more presets. Any channel
changes that were made since starting the record process will be included in any new presets. To start a
new preset from scratch, toggle the “preset” LED off and then back on while the “record” LED is still
flashing.
To exit record mode, press “record”, all LEDs will stop flashing.
RECALLING PRESETS
To play back a preset, first select the fixtures that you want to control with the preset. The fixtures must
have been included in the recording of the preset to be affected. Next, press the “preset” switch, select the
page of the desired preset then use the number switches to select from the presets on that page. Unlike
scenes, you can have several presets on at the same time as long as each preset is controlling different
channels or fixtures. If two different presets are trying to control the same channel, the last preset that was
selected will have control of the channel. If a preset has been completely overridden by another, it will be
automatically switched off.
A fixture must first be selected before the preset is turned on even if it that fixture was included in the
preset when it was recorded. This allows you to put all fixtures into a preset but use only selected ones as
needed. For example you could create a preset called “Red” that sets all color channels of every fixture to
the color red. Then you can select the fixtures you want to be red then call the “Red” preset changing only
those fixtures.
ERASE PRESET
To erase an existing preset, press “record” then “preset” then “erase”. As when recording a preset, all
LEDs that contain a preset will light. Next select the preset to erase. That preset name will appear in the
display. The message “Erase this Preset?” will also appear along with the preset name. Press “yes” or “no”.
If you press “yes” the preset will be erased. You can then select additional presets to be erased or you can
press “record” again to exit record mode.
Note: It can take up to 30 seconds to overwrite or erase a preset depending on how much of the memory
is currently filled.
EDITING PRESETS
To edit a preset that has already been recorded, press “record” followed by “preset”. Before making any
channel changes, press the preset number of the one you want to edit. The message “Edit this existing
Preset?” will appear in the display. Press “yes” and the preset will be called up and you can add to it or
modify it by changing any channel levels. After making changes you can store it at the same or at a new
(60 Seiten)
(16 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern